Freight Harness Purple neoprene padding neck 18 x 22 rear CLEARANCE

This traditional singletree harness is used for weight pulling, sledding, and heavy-duty hauling.  Frequently, it is used in wheel position (near the sled) because  the low-draft hitch is more level with the gangline.  This harness comes with a hardwood spreader kit.  The spreader bar should be slightly wider than the rear of the dog.   You may cut the bar if needed.  The spreader bar should be touching the rear of the dog when the harness is in a relaxed position.  Put the screws provided through the fabric and into the pre-drilled spreader bar.  The height of the hitch is adjustable, so the load is always held in place for maximum pull.  The hitch ring uses limited side slip to compensate for off-center loads, and the backstraps feature the same “sliding X” as the X-back harness.

THIS IS A CLEARANCE ITEM AND  NOT RETURNABLE!!!  MAKE SURE YOUR MEASUREMENTS ARE CORRECT!!!

This harness requires a neck and rear measurement.  Instructions for measuring are found under information-measuring dogs.